• Set Protective strip 150mm 5m + Professional adhesive 330g

160.00
opak Add to wishlist
Shipping within 24H
Shipping price 89
Anglia 89

Zadzwoń i zamów: 795244917 lub 577757706

Leave your phone

A protective slat for a 150 mm dinghy.

We offer you an original protective slat for inflatable boats and kayaks.

This slat is designed to strengthen the bottom and sides of a pontoon or kayak and guarantees safety when using equipment on rivers and reservoirs with a rocky shore or bottom, or with a lot of branches in the water. Strengthening the bottom of the pontoon increases damage resistance up to 300%. The slat is made of flexible material and is very easy to stick even for a person who has never done it.

We also recommend other slats for tuning the pontoon that are on our auctions. All the slats we sell are suitable for inflatable boats of such producers: Kolibri Bark Eling Storm Navigator.

 

Professional glue 330g can + brush and tape

Polyurethane adhesive for repair and modification of inflatable boats, trampolines, etc.. This glue is used in the production of inflatable boats in factories and is recommended for sticking various handles and accessories to the inflatable boat. Designed for quick and reliable repair of PVC products that are used outdoors. In sea or fresh water. Resistant to UV rays.

Recommended for quick and quality repairs, both in tourist and home conditions:
- boats and inflatable boats,
- trampolines and inflatable objects,
- automotive inner tubes,
- commercial pavilions,
- tourist tents, kayaks, canoes, catamarans and sports and tourist footwear.

Cold glue method:
1) Mark the place for the patch. Cut a patch from fabric or PVC film in a size that is 4-5 cm larger than the damaged area.
2) Clean and degrease the patch and the patch site.
3) Apply a thin layer of glue on both surfaces to be glued.
4) Dry for 5-10 minutes. Apply the second layer of glue and dry for 3-5 minutes. It is important to mark the moment when the glue stickiness starts to disappear (check by touching with your finger), put the patch into place and press firmly. We recommend leaving the gluing point under pressure for 3-4 hours. The glued equipment can be used after 3-4 hours.

Hot glue method:
1) Mark the place for the patch. Cut a patch from fabric or PVC film in a size that is 4-5 cm larger than the damaged area.
2) Clean and degrease the patch and the patch site.
3) Apply a thin layer of glue on both surfaces to be glued.
4) Dry for 5-10 minutes. Apply the second layer of glue and dry for 5-10 minutes.
5) Heat the glued surfaces to a temperature of 60 ° С, put the patch in place and press it firmly. The glued equipment can be used after 20 minutes.

Recommendations and tips:
Glue cuts and damages larger than 4 cm on both sides. We recommend repairing cuts and damages with a length greater than 6 cm in specialized workshops. Repaired equipment in tourist conditions with greater damage, we recommend that you repair it again at the first opportunity with two-component glue. Operating temperature of glued equipment from - 40 ° С to +80 ° С. Repair at a temperature greater than 10 ° С. Store and transport at a temperature of - 10 ° С to + 30 ° С. Fresh glue is removed with alcohol or acetone. We achieve the maximum effect after 24 hours. CAUTION FLAMMABLE! Keep out of the reach of children. Work should be carried out in a ventilated room and access to fire should be avoided. Made in Ukraine.


Video instructions on how to stick a protective slat on the pontoon (pontoon bottom armoring)

There is currently no comments or ratings for this product.
  • Rate

The Whole Thing
The Functionality Of The
Price
The Signature Of The
Opinion Of The